Problems in Design of Reinforced Concrete Structures

　　1結構體系不合理

　　1. unreasonable structure system

　　鋼筋混凝土結構在進行設計時，設計人員需要結合工程結構特點，同時參考抗震等級以及風荷載情況，選擇合理的結構體系。但是，如果選擇的結構體系不合理，將會影響結構的穩定性，使其結構性能降低，如果設計人員選擇的設計指標不科學，也將會降低結構設計的可行性和科學性，導致建筑質量出現問題，甚引發事故。

　　In the design of reinforced concrete structures, designers need to choose a reasonable structure system according to the characteristics of Engineering structures, seismic grade and wind load. However, if the selected structural system is not reasonable, it will affect the stability of the structure and reduce its structural performance. If the design indicators chosen by the designers are not scientific, it will also reduce the feasibility and scientificity of the structural design, resulting in problems in building quality and even lead to safety accidents.

　　2下部結構設計中存在的問題

　　2. Problems in the design of substructure

　　（1）地下室底板設計。由于建筑上部結構受到的荷載致使柱下獨立基礎和地下室頂板發生沉降變形。設計時如果對這種情況不能引起足夠的重視，則會導致地下室頂板承受壓力過大，超過極限后極容易發生斷裂現象，導致建筑發生傾斜甚結構斷裂。（2）地下室底板配筋不合理。地下室作為基礎結構的一部分，具有增強建筑物結構的穩定性、承載能力以外，還能削減地震破壞程度。在地下室設計時，若地下室底板配筋不合理，會導致鋼筋混凝土結構出現失穩現象，增加建筑物的不均勻沉降量。（3）天然基礎設計不合理。在對天然地基中的獨立基礎進行設計時，采用了不合理的設計，斜面坡度大于1:3，這使得地基混凝土振搗不密實，影響振搗質量，影響地基結構的穩定性。實際施工過程中，常運用人工振搗拍打的方式振搗混凝土，但是振搗質量不易控制，甚不能達到設計要求強度。（4）地下水位的影響。在鋼筋混凝土結構設計中，地下水位的影響對其結構的穩定性影響較大，在設計過程中應尤其注意地下水位變化較大的地方，重視建筑防水及降水問題，對建筑工程施工進度以及質量控制有重要的作用。同時，整個建筑基礎結構設計中，基礎受到上部結構荷載作用，一旦發生沉降變化，地下室頂板和柱子將共同受力。

　　(1) Basement floor design. Because of the load on the superstructure of the building, the settlement and deformation of the independent foundation under the column and the roof of the basement occur. If we do not pay enough attention to this situation in design, it will cause the basement roof to bear too much pressure, and it will easily break after exceeding the limit, leading to the inclination of the building and even structural fracture. (2) The reinforcement of basement floor is unreasonable. Basement, as a part of infrastructure, can not only enhance the stability and bearing capacity of building structure, but also reduce the degree of earthquake damage. In basement design, unreasonable reinforcement of basement floor will lead to instability of reinforced concrete structures and increase the uneven settlement of buildings. (3) The design of natural foundation is unreasonable. In the design of independent foundation in natural foundation, unreasonable design is adopted. The slope is more than 1:3, which makes the vibration of foundation concrete not compact, affects the quality of vibration, and affects the stability of foundation structure. In the actual construction process, manual vibration is often used to vibrate concrete, but the quality of vibration is not easy to control, or even can not meet the design strength requirements. (4) The influence of groundwater level. In the design of reinforced concrete structure, the influence of groundwater level has a great influence on the stability of its structure. In the design process, special attention should be paid to the place where the groundwater level changes greatly, and attention should be paid to the waterproof and dewatering of buildings, which plays an important role in the construction progress and quality control of construction projects. At the same time, in the design of the whole building foundation structure, the foundation is subjected to the load of the superstructure. Once the settlement changes, the basement roof and the pillar will bear the force together.

　　上部結構設計中存在的問題

　　Problems in Superstructure Design

　　在鋼筋混凝土結構設計中，上部結構相對與下部結構來說，理論較為成熟，存在的問題也相對較少，主要體現在三個方面：，框架剪力墻設計時，如果設計不合理，則會導致應力較為集中，威脅建筑結構的性，當發生地震時，建筑結構容易出現坍塌，另外，剪力墻分布不均也會增加框架剪力墻連接構件的設計難度，不利于建筑結構的穩定性和可靠性。其次，在以鋼筋混凝土結構為主的建筑中，抗側力主要的構件是鋼筋混凝土，因此，鋼筋混凝土結構測量位移必須要滿足規定的側向位移限值，如果超過限值，將會導致建筑結構的穩定和受到影響。后，裂縫問題是鋼筋混凝土工程中不可忽視的部分，分為構造裂縫和結構裂縫，其中構造裂縫是由于施工技術人員操作不當或者不規范導致的，如混凝土振搗不充分、水灰比不合理、養護不到位，模板位置改變或者過早脫模等均會導致構造裂縫的發生。而結構裂縫出現在鋼筋混凝土結構的澆筑過程中，這是由于不同構件之間的剛度存在差異，形成了剛度薄弱區域，導致結構中出現裂縫，常見于樓板頂端或者墻角等位置。

　　In the design of reinforced concrete structures, the theory of superstructure is relatively mature and the existing problems are relatively few, which are mainly reflected in three aspects: first, if the design of frame shear wall is unreasonable, it will lead to more concentrated stress and threaten the safety of the building structure. When earthquake occurs, the building structure is prone to collapse. The uneven distribution of shear walls will also increase the difficulty in the design of frame-shear wall connections, which is not conducive to the stability and reliability of building structures. Secondly, in the building with reinforced concrete structure as the main component, the most important component to resist lateral force is reinforced concrete. Therefore, the measured displacement of reinforced concrete structure must meet the prescribed lateral displacement limit. If it exceeds the limit, the stability and safety of the building structure will be affected. Finally, the problem of cracks is an important part in reinforced concrete engineering, which can be divided into structural cracks and structural cracks. The structural cracks are caused by improper or non-standard operation of construction technicians, such as inadequate vibration of concrete, unreasonable water-cement ratio, inadequate maintenance, change of template position or premature demoulding. The structural cracks occur in the pouring process of reinforced concrete structure, which is due to the stiffness difference between different components, forming a weak stiffness area, resulting in cracks in the structure, often at the top of the floor or corner.

　　4結構抗震設計存在的問題

　　Existing Problems in Seismic Design of 4 Structures

　　鋼筋混凝土結構設計時，一定要考慮結構的抗震性能等級，這對建筑的使用具有十分重要的意義。地震是較為常見的自然災害，其對建筑結構的影響是由內而外的，地震縱波對建筑物結構施加作用力，導致堅固的結構外表出現松動等、裂縫等變化，嚴重威脅著建筑結構的穩定性。雖然我國不是地震頻發的，但近幾年幾場較大地震災害的發生以及以往的經驗也表明了，具有高抗震等級的建筑物在地震中穩固性和性相對較高，因此，提高建筑物的抗震性能是當前人們關注的。由于鋼筋混凝土結構本身具有的特性，使其抗震性能較低，這也是當前需要的問題。

　　In the design of reinforced concrete structures, the seismic performance grade of structures must be considered, which is of great significance to the safety of buildings. Earthquakes are common natural disasters, which affect the structure of buildings from the inside to the outside. The longitudinal wave of earthquakes exerts a force on the structure of buildings, resulting in changes in the appearance of solid structures such as loosening, cracks and so on, which seriously threatens the stability of building structures. Although China is not a country with frequent earthquakes, the occurrence of several major earthquake disasters in recent years and past experience also show that buildings with high seismic grade have relatively high stability and safety in earthquakes. Therefore, improving the seismic performance of buildings is the focus of current attention. Because of the characteristics of reinforced concrete structure itself, its seismic performance is low, which is also a key problem to be solved at present.