鋼筋網片是通過橫向和縱向鋼筋的綁扎或焊接而成的
The steel mesh is made by binding or welding the transverse and longitudinal reinforcement
為保證工程質量，焊接鋼網由自動化、智能化生產線在工廠嚴格的質量控制下生產。嚴格控制網架尺寸、鋼筋規格和質量?？杀苊饴┑羰止ぱb訂網，裝訂不牢，裝訂錯誤，切斷工作和材料的情況。網孔剛度大，彈性好，間距均勻準確，焊接點強度高，大大提高了工程質量。
In order to ensure the engineering quality, welded steel mesh is produced by automatic and intelligent production line under strict quality control of the factory. Strictly control the grid size, steel bar specification and quality. It can avoid missing manual binding net, binding is not firm, binding error, cutting off work and materials. The mesh rigidity is big, the elasticity is good, the spacing is uniform and accurate, the welding point strength is high, and the engineering quality is greatly improved.
為了提高鋼筋混凝土結構的抗震抗裂性能，焊接鋼筋網縱橫筋形成網狀結構，與混凝土具有良好的粘結錨固性能，所受荷載分布均勻，能顯著提高鋼筋混凝土結構的抗震抗裂性能鋼筋混凝土結構。根據實際試驗，在道路上鋪設焊接鋼筋網可以減少75％以上的裂縫。
In order to improve the anti-seismic and anti cracking performance of reinforced concrete structure, the longitudinal and horizontal bars of welded steel mesh form a mesh structure, which has good bond anchorage performance with concrete, and the load distribution is uniform, which can significantly improve the seismic and crack resistance performance of reinforced concrete structure. According to the actual test, more than 75% of the cracks can be reduced by laying welded steel mesh on the road.
地面鋼筋網主要用于橋梁、公路、建筑工地、建筑物、隧道、機場跑道、墻壁、地板等。
The ground reinforcement mesh is mainly used in bridges, highways, construction sites, buildings, tunnels, airport runways, walls, floors, etc.
The following Jinan Steel wholesale for you to introduce the characteristics of steel mesh.
地面鋼筋網特點：
Features of ground reinforcement mesh:
確保工程質量。提高抗震抗裂性能。節省鋼筋用量。加快建設進度使用磨細的鋼筋網可以加快工程的施工速度。只要按要求鋪設焊接好的鋼筋網，就可以澆灌混凝土，省去了現場鋼筋選擇、逐根澆筑、綁扎等環節。
Ensure the quality of the project. Improve the anti-seismic and anti cracking performance. Save the amount of reinforcement. To speed up the construction progress, the use of fine steel mesh can speed up the construction speed of the project. As long as the welded steel mesh is laid according to the requirements, the concrete can be poured, and the links such as site reinforcement selection, pouring one by one and binding are omitted.
焊接網鋼筋的設計強度比一級鋼筋（素筋焊接網）高50％70％（護欄網焊接網）?？紤]橋梁鋼筋網的一些結構要求，鋼筋仍能節省約30％，直徑小于12mm的松筋加工成本約為材料成本的10％-15％。結果表明，考慮鋼筋網片后，加固工程造價可降低10％左右。
The design strength of welded mesh reinforcement is 50% to 70% higher than that of grade I reinforcement (plain welded mesh). Considering some structural requirements of the bridge reinforcement mesh, the reinforcement can still be saved about 30%, and the processing cost of loose reinforcement with diameter less than 12mm is about 10% - 15% of the material cost. The results show that the reinforcement cost can be reduced by about 10% after considering the reinforcement mesh.
The above is about the steel mesh structure and characteristics of the relevant introduction, I believe that you have understood, want to know more content, welcome to pay attention to Jinan Steel wholesale http://www.ozhouu.com Official website.
咨詢熱線： 13605413762
